Meteorological environment monitoring equipment supplier
Insist on doing high-precision customer favorite technology products
1. Product principle ofradar water level meter
Radar water level meter is also called radar water level monitoring system and radar water level meter. Radar water level meter is a simple and fast non-contact liquid level measurement using microwave radar technology. It is suitable for measuring the level of liquids, slurries and granular materials. Continuous measurement is suitable for situations where temperature and pressure change greatly, and where inert gases and volatilization exist. The radar level antenna emits narrow microwave pulses, which are transmitted downward through the antenna. After the microwave contacts the surface of the measured medium, it is reflected back and is received again by the antenna system. The signal is transmitted to the electronic circuit part and automatically converted into a level signal (because the microwave propagates extremely fast, the electromagnetic wave reaches the target and is reflected back to the receiver. The time taken is almost instantaneous).
2. Technical parameters of radar water level gauge
Application: temperature-resistant, pressure-resistant, slightly corrosive liquids
Measuring range: 30 meters
Process connection: thread, flange
Medium temperature: -40~250℃
Process pressure: -0.1~4.0MPa
Accuracy: ±3mm
Protection level: IP67
Frequency range: 26GHz
Explosion-proof level: ExiaⅡC T6 Ga/Exd ia IIC T6 Gb
Signal output: 4...20mA/HART (two wires/four wires) RS485/Mod bus
3. Product features of radar water level meter
The antenna is small in size and easy to install; the non-contact radar has no wear and pollution.
Almost unaffected by corrosion and foam; almost unaffected by water vapor, temperature and pressure changes in the atmosphere.
Serious dust environment has little impact on the operation of high-frequency level meters.
The wavelength is shorter and reflects better on tilted solid surfaces.
The beam angle is small and the energy is concentrated, which enhances the echo capability and helps avoid interference.
The measurement blind area is smaller, and good results can be achieved for small tank measurements.
High signal-to-noise ratio for better performance even under fluctuating conditions.
High frequency, it is the best choice for measuring solids and low dielectric constant media.